V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Checking the gear selector slider
Check that the lever for the gear selector slider is correctly positioned.
Installing the control system
Note: Ensure the lever for the gear selector is set to neutral.
Align the control system on the lever for the gear selector.
Install:
-
the screws for the control system
-
a new gasket for the cover on the control system. Note that the screws are of different lengths (measured in mm).
Lightly tighten the screws alternately. Then tighten alternately.
Tighten to 10 Nm.
Finishing
Install the cable harness. Connect the connectors to the solenoids. Install the oil temperature sensor with the holder and the screw. Note that the length
of the screw is given in mm. Tighten to 10 Nm. Install the cable harness on the holder. Check that the cable harness is correctly positioned.
Reinstall. See Wiring harness / oil temperature sensor, replacing.
