Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Brakes and Traction Control > Disc Brake System > Brake Rotor/Disc > Component Information > Testing and Inspection > Measuring Lateral Wheel Hub Movement [SSS] > Page 5086

Page 1
background image

Brake Rotor/Disc: Testing and Inspection
Measuring Brake Disc Lateral Movement [TTT]

TTT. Measuring brake disc lateral movement

TTTA. Measuring lateral run-out on brake disc

Special tools: 115 8147, 999 5418, 999 5442, 999 5507

[TTTA1]

Preparations

- Get measurement tool set 999 5418, 999 5418.

Front:Remove brake caliper from caliper mounting as per [MMMA1-MMMA4]  See: Brake Pad/Service and Repair
Rear:Remove brake caliper from rear axle, see [RRRA4], then continue as below.  See: Brake Pad/Service and Repair

[TTTA2]

Installing clamp ring

Hubs with four wheel bolts: Install clamp ring 999 5442 on hub with wheel nuts.

Hubs with five wheel bolts:

- Install clamp ring 999 5419 from measurement tool set 999 5418 on hub with wheel nuts.
- Make sure that contact surfaces on brake disc and clamp ring are clean.
- Tighten bolts hand tight, then tighten across to 110 Nm (80 ft lb). When tightening with airgun, use torque socket 115 8147.

[TTTA3]

Installing test equipment

Brakes and Traction Control > Disc Brake System > Brake Rotor/Disc > Component Information > Testing and Inspection > Measuring Lateral Wheel Hub Movement [SSS] > Page 5086

[PREV PAGE] [NEXT PAGE]