Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Camshaft Gear/Sprocket > Component Information > Service and Repair > With Mechanical Adjuster > Page 1762

Page 3
background image

-

Remove brake vacuum hose from intake.

-

Remove control module box air duct and air cleaner (ACL) intake air hose.

-

Remove connectors, relays and canister purge (CP) valve from fan shroud. Place wiring to one side.

-

Remove screws from fan shroud and relay holder mounting.

-

Lift relay holder.

-

Lift up engine cooling fan (FC) with cover.

Install camshaft adjustment tool

-

Remove starter motor mounting screws (x3). Place starter motor to one side.

-

Remove blind cover plug.

-

Turn the crankshaft slightly clockwise.

-

Install camshaft adjustment tool 999 5451 . Ensure that it reaches down as far as the cylinder block.

-

Carefully turn crankshaft counter-clockwise as far as it will go against the camshaft adjustment tool.

-

Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.

Install timing gear pulleys and timing belt

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Camshaft Gear/Sprocket > Component Information > Service and Repair > With Mechanical Adjuster > Page 1762

[PREV PAGE] [NEXT PAGE]