Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Camshaft Oil Seal > Component Information > Service and Repair > With Mechanical Adjuster > Page 1994

Page 3
background image

Remove blind cover plug and install gauge 999 5451 for the crankshaft, turn the crankshaft counter-clockwise until it stops against the drift.
Install gauge 999 5452 in the rear edge of camshafts and the extensions.

Install 

-

camshaft pulleys, with two screws so that they precisely act on the pulleys

-

tensioner damping unit

-

timing belt

Note!

Check that the camshaft screw holes are centered, see illustration.

Adjusting the mechanical belt adjuster

If a mechanical belt adjuster is being used, adjust accoreding to Adjusting the Mechanical Belt Adjuster   See: Timing Components/Timing Belt
Tensioner/Adjustments

Tighten timing belt 

Remove the lock pin from the tensioner damping unit.
Press hard or knock the belt twice in the direction of arrow (1) and twice in the direction of arrow (2) using a plastic mallet.

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Camshaft Oil Seal > Component Information > Service and Repair > With Mechanical Adjuster > Page 1994

[PREV PAGE] [NEXT PAGE]