Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 2004

Page 2
background image

-

Install the other standard screws, using new screws, and tighten to 45 Nm (33 ft lb).

-

Replace the three special screws with new standard screws and tighten diagonally to: 45 Nm (33 ft lb) 

-

Angle tighten all screws an additional: 65°

Automatic Transmission:
-

Install the drive plate, tighten in two stages:

Tighten to: 45 Nm (33 ft lb)
Angle tighten: 50° 

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 2004

[PREV PAGE] [NEXT PAGE]