Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Fuel Sending Unit - Installation > Page 3722
Separate the connector for the sending unit.
Move the harness from the sender over to the right side of the vehicle.
Attach a string or similar to the connector as per illustration.
Carefully pull over the harness with the connector to the access hole of the sending unit.
Place the string so that the harness of the new sending unit can be pulled back over again.
Remove fuel sending unit
Place the retaining nut back on the threaded neck if the new sending unit is not installed immediately. The threaded neck may deform if left open.
Remove the retaining nut with special tool 999 5486.
Carefully pull up the sending unit half way, letting the fuel inside the tube drain out.
Ensure so that no fuel spill occurs while lifting the sending unit out of the vehicle.
|[PREV PAGE] [NEXT PAGE]|