Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Sensors and Switches > Sensors and Switches - Body and Frame > Power Seat Switch > Component Information > Technical Service Bulletins > Front Seat - Height Adjuster Knob > Page 523

Page 2
background image

Carefully bend out the lock tab on the inside of the knob. 

Pull the knob upwards. (See illustration)

2

Marking and drilling holes

Warning!

When drilling holes, use eye protection.

Mark up where the hole is to be drilled.

A =23.4 + 0.3 mm (59/64" + 0.010") from the upper edge.

B =9.0 + 0.2 mm (29/64" + 0.008") from the side edge. 

Position counterhold behind the height adjustment lever so that lever and the plastic cover are not damaged during centerpunching and drilling. A 5 mm
(1/4") flat steel bar or equivalent is suggested.

Carefully center punch before drilling. 

Drill holes, 3.5 mm (9/64").

3

Marking and drilling holes

Sensors and Switches > Sensors and Switches - Body and Frame > Power Seat Switch > Component Information > Technical Service Bulletins > Front Seat - Height Adjuster Knob > Page 523

[PREV PAGE] [NEXT PAGE]