Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Sensors and Switches > Sensors and Switches - Body and Frame > Power Seat Switch > Component Information > Technical Service Bulletins > Front Seat - Height Adjuster Knob > Page 524

Page 3
background image

Warning!

When drilling holes, use eye protection.

Mark up where the hole is to be drilled.

A = 21.7 + 0.3 mm (55/64 + 0.010") from the upper edge.

B = 9.1 + 0.2 mm (29/64" + 0.008") from the side edge. 

Position counterhold between the height adjustment lever and its cover. A 5 mm (1/4") flat steel bar or equivalent is suggested.

Position the counterhold in such way that the cover is not damaged during or after drilling.

Carefully center punch before drilling. 

Drill holes, 3.5 mm (9/64").

4

Installing control knob (front and rear)

Install new adjuster knob.

Install 2 new screws (part number 980893).

Tighten to 2.5 Nm (1.8 ft.lb).

WARRANTY STATEMENT: Claims may be submitted under the New Car Warranty when there is a documented customer complaint, using claim type
01.

Operation No. 

Labor description

Time allowance

85224-2

Replacing seat control knob

0.1hr

Sensors and Switches > Sensors and Switches - Body and Frame > Power Seat Switch > Component Information > Technical Service Bulletins > Front Seat - Height Adjuster Knob > Page 524

[PREV PAGE] [NEXT PAGE]