Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Transmission and Drivetrain > Automatic Transmission/Transaxle > Valve Body, A/T > Component Information > Service and Repair > Open The Control System > Page 4524

Page 1
background image

Valve Body: Service and Repair
Solenoid Wire Harness Inspection/Replacement

SPECIAL TOOLS

-

Lifting frame tool No. 999 5006, or equivalent

-

Support rails tool No. 999 5033, or equivalent

-

Lifting hook tool No. 999 5460, or equivalent

-

Separator tool No. 999 5477, or equivalent

-

Protective Sleeve tool No. 999 5562, or equivalent

-

Mobile Jack tool No. 998 5972, or equivalent

-

Tool No. 998 8670, or equivalent

-

Protractor tool No. 951 2050, or equivalent

-

Refer to special tool section for additional tool information. See: Tools and Equipment

1. Preparation

-

Refer to steps 1 through 14 of Open The Control System. See: 

Inspection/Replacement Of Wiring Harness

2. Preparation

-

Remove:

ACL complete with inlet pipe.
ACL bracket.

-

Disconnect transmission connector.

Remember rubber seal.

3. Checking of wiring harness

-

Use ohmmeter to measure resistance between transmission connector and end of appropriate solenoid cable.

Shake harness gently during measurement to locate possible loose connections.
The ohmmeter should indicate 0 ohms.

-

Connector Pin/Wire Color Codes

Pin No: 21

Solenoid/Color: S1/white

Pin No: 22

Solenoid/Color: S2/black

Pin No: 23

Solenoid/Color: SL/red

Pin No: 24 

Solenoid/Color: STH/brown

Pin No: 25

Solenoid/Color: STH, ground/blue

Transmission and Drivetrain > Automatic Transmission/Transaxle > Valve Body, A/T > Component Information > Service and Repair > Open The Control System > Page 4524

[PREV PAGE] [NEXT PAGE]