Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Transmission and Drivetrain > Manual Transmission/Transaxle > Seals and Gaskets, M/T > System Information > Service and Repair > Transaxle Side Seals, M/T > Page 4687

Page 3
background image

6. Installing driveshafts.

NOTE:  Take care not to damage driveshaft seals or boot (gaiter).

RH driveshaft:
-

Install bearing cap. Tighten to 25 Nm (18 ft. Lb.).

-

Install splashguard under engine. (Earlier models).

LH driveshaft:
Push driveshaft in properly so it locks into the circlip in the differential slot.

Make sure driveshaft circlip engages in slot.
Check by pushing in driveshaft inboard universal joint carefully.

Transmission and Drivetrain > Manual Transmission/Transaxle > Seals and Gaskets, M/T > System Information > Service and Repair > Transaxle Side Seals, M/T > Page 4687

[PREV PAGE] [NEXT PAGE]