V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
- Disconnect pump motor connection from control module.
- Remove bracket and control module from hydraulic unit.
Checking hydraulic unit
Check that the hydraulic unit is of the correct type, depending on whether the car is fitted with TRACS. The difference is that the TRACS hydraulic
unit has seven valves between it and the control module instead of six.
The hydraulic unit must not be opened under any circumstances. Special equipment is needed for re-assembly.
Installing hydraulic unit
The hydraulic unit is full of brake fluid. It is important not to remove the protective plugs until the brake pipe is connected.
Check and install the control module to the hydraulic unit as per MMMM. Control module, replacement. See: Electronic Brake Control
Module/Service and Repair Install bolts. Tighten to 1.8 Nm.
- Install the new hydraulic unit on the bracket and tighten the mounting bolts. Tighten to 8 Nm.
- Hold down the vacuum hose and install bracket carefully.
- Connect pump motor connector to control module.
- Tighten mounting bolts to 8 Nm.
In cars with TRACS