V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Wheel Speed Sensor: Service and Repair
Replacing Front Wheel Sensor Wiring
Replacing front wheel sensor wiring
The wiring to the front wheel sensor is integrated into the engine compartment wiring. In the past, damage to the wheel sensor wiring has meant
replacing all engine compartment wiring. A repair kit for the front wheel sensors is now available as a replacement part.
Note: The earlier repair kit, P/N 9442120-3, should no longer be used
Replacing wheel sensor cable harness
Raise the car and remove the wheel on the side on which the wiring is to be replaced.
Disconnect cable harness from:
Brackets on spring strut and in wheel arch.
Clip on brake pipe
Clip in engine compartment
Pull up the cable harness in the engine compartment.
The new cable harness should be routed in the same way as the old to avoid damage caused by rubbing.
Cut off the old cable harness approximately 20 cm from the cable duct and discard.