Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Axle Shaft > Component Information > Service and Repair > Front > Page 5013
6. LH driveshaft:
Remove driveshaft from transmission.
Use prying tool No. 999 5462, or equivalent, to apply leverage between transmission and inside of driveshaft.
NOTE: Take care not to damage driveshaft seal or boot (gaiter).
Counterhold Tool No. 999 5461, or equivalent
Counterhold Tool No. 999 5540, or equivalent
Torque Sleeve Tool No. 115 8147-7, or equivalent
Protractor tool No. 951 2050, or equivalent
NOTE: The Procedure is the same for both LH and RH driveshafts unless stated otherwise.
Check that ABS sensor and sensor wheel are free of dirt.
1. Install driveshaft to transmission.
NOTE: Take care not to damage driveshaft seal or boots (gaiter).
Install bearing cap.
Tighten to: 25 Nm.
Install splashguard under engine (earlier models only).
|[PREV PAGE] [NEXT PAGE]|