Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5038
Tap shaft into joint.
Check that circlip is seated in its groove.
7. Pack the remaining grease into joint.
NOTE: Take care not to get any grease on the part of the boot (gaiter) in contact with the joint and shaft.
Clean off any excess grease using methylated (mineral) spirits.
Slide boot (gaiter) onto the joint and check it is correctly positioned on the driveshaft.
Use pliers tool No. 981 4215, or equivalent.
Driveshaft, automatic transmission AW 50-42
8. Expose inboard universal joint
Remove clips from inboard boot (gaiter).
Slide boot (gaiter) off inboard universal joint.
9. Dismantling universal joint
Mark driveshaft position relative to joint casing.
Bend casing plate tabs back slightly and remove shaft from joint casing.
|[PREV PAGE] [NEXT PAGE]|