Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5040
New boot (gaiter) on driveshaft.
Spider, lining up as above.
NOTE: Spider's position relative to shaft (non-turbo models only).
Tap spider down until it reaches the stop.
Use Drift tool No. 999 5519, or equivalent.
Install circlip, making sure it engages in its groove.
Assembling inboard and outboard driveshafts
14. Non-turbo models:
Pack grease into joints.
15. Turbo models:
Install needle bearings on spider.
Grease spider pins, use grease pack part No. 1161430-2 (190g), or equivalent.
Pack grease into joint, use grease pack part No. 1161430-2 (190g), or equivalent.
|[PREV PAGE] [NEXT PAGE]|