Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5041
16. Fit spider onto joint, lining marks up.
Tap plate flaps back properly.
NOTE: Tap joint tabs back carefully: avoid sharp edges or angles.
Pack remaining grease into joint.
NOTE: Check that no grease gets onto boot (gaiter) where it touches driveshaft or joint.
Wipe off excess grease with methylated (mineral) spirits.
17. Slide boot (gaiter) over joint.
Check that it is correctly positioned on driveshaft.
Replacing support bearing, manual automatic models
18. Remove circlip and support bearing from shaft.
Use ring tool No. 999 2853, or equivalent.
Support tool and shaft as in picture.
|[PREV PAGE] [NEXT PAGE]|