V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Seals and Gaskets: Service and Repair
Input Shaft Seal
Extractor tool No. 999 5489, or equivalent
Drift tool No. 999 5490, or equivalent
Refer to special tool section for additional tool information. See: Tools and Equipment
Before replacing gearbox input shaft seal, follow:
Steps 1 through 26 of transmission removal. See: Service and Repair
Step 2 of clutch replacement. See: Clutch/Service and Repair
1. Remove throwout (release) bearing sleeve.
Remove the three screws holding the sleeve.
2. Tap in extractor tool No. 999 5489, or equivalent.
NOTE: Jackscrew in extractor must be unscrewed.
Check that extractor grips input shaft seal. Remove Input shaft seal.
3. Install new input shaft seal.
Grease input shaft seal lip.
Use drift tool No. 999 5490, or equivalent
Tap seal in until drift touches transmission cover.
4. Install throwout (release) bearing sleeve.
Apply a little locking fluid to the bolts.