V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Drill a 5 mm hole in the plate between the clamp for the backrest mounting and the clip for the wire for the seat belt tensioner.
Position the hole approximately 15 mm (0.6 ) from the clip.
Remove any burs.
ground lead using screw p/n 958244. Route the ground lead along the existing wire through the backrest upholstery
cable for the seat belt tensioner in the clip.
Installing the backrest cushion
Push the padding and upholstery back into position. Pull the tie strap closed at the inner edge of the backrest upholstery.
guide for the inner mounting for the cushion
inner half moon clip and ring for the strap for the seat belt
remaining half moon clips
backrest (1). Tighten to 48 Nm (35 lbf.ft).
Connect the seat belt tensioner connector.
Install the strap for the seat belt buckle.