V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Fig. 28 Front Seat Removal
Install front seat
-
Install seat in opposite order of removal.
NOTE: The outside rear attachment bolt (C) should be tightened last, otherwise the seat could be installed at an angle.
After collision, replace seat pocket.
Tightening torques:
-
Seat/floor: 40 Nm (30 ft.lb.)
-
Belt: 20 Nm (15 ft.lb.)
When front seat is in place Do not forget to unlock SIPS bag!
-
Remove transport safety device from sensor unit.
-
Place transport safety device in holder inside seal pocket.
-
Replace seat pocket.