Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5072

Page 6
background image

16. Fit spider onto joint, lining marks up.

Tap plate flaps back properly.
Turbo models: 

NOTE:  Tap joint tabs back carefully: avoid sharp edges or angles.

Pack remaining grease into joint.

NOTE:  Check that no grease gets onto boot (gaiter) where it touches driveshaft or joint.

-

Wipe off excess grease with methylated (mineral) spirits.

17. Slide boot (gaiter) over joint.

Check that it is correctly positioned on driveshaft.
Install new cups.
Use pliers tool No. 981 4215, or equivalent.

Replacing support bearing, manual automatic models

18. Remove circlip and support bearing from shaft.

-

Use ring tool No. 999 2853, or equivalent.

Support tool and shaft as in picture.

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5072

[PREV PAGE] [NEXT PAGE]