V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Note! If the dust boot is damaged dirt may have penetrated the cylinder. The brake caliper must be replaced.
Checking the brake disc
Check the brake disc's friction surface.
If the brake disc shows signs of warping, check lateral warp (run-out) according to Brake disc front, calibrating See: Brake Rotor/Disc/Testing and
Inspection/Brake Disc Front, Calibrating.
Disc thickness, front
Minimum disc thickness/replacement limit = 30.0mm. The minimum recommended disc thickness when installing new brake pads = 30.8mm.
Disc thickness, rear
Minimum disc thickness/replacement limit = 26.0mm. The minimum recommended disc thickness when installing new brake pads = 26.7mm.
Installing brake pads
Only front brakes
Press back the pistons in the brake caliper with a large screwdriver.
Note! The brake pads are marked with an arrow on the reverse which must point downwards.
Grease the brake pad mating surfaces towards the brake caliper using silicone grease, part no. 1161687 (12 ml) or part no. 1161688 (50 ml)
Install:
-
brake pads.
-
the shims on the back of the brake pad
-
damping spring
-
lock pins.
Note! Shims shall not be installed on vehicles with vibration damper or on vehicles from and incl. chassis number V70 500817-, S60 466813-.
Only rear brakes