V70R AWD L5-2.5L Turbo VIN 52 B5254T4 (2004)
Replace the rear cable harness with a new one.
On the new cable harness there is an integrated connection to the control module.
Use: Cable harness S60 and S60R MY2005, 30773828
Use: Cable harness S60R MY 2004, 30773260
Use: Cable harness V70 and V70R MY2005, 30773833
Use: Cable harness V70R MY2004, 30773261
Plug in the connector by the sill and the fuel pump.
Place the cable harness in the seal ring's slot and in the brackets on the body.
Install the floor hatch and tighten with 6 Nm.
Check carefully that the seal is in place when the hatch is installed.
The control module shall be placed in the spare wheel well's rear part on the right side, between the two markings and below the bead of sealing
compound.
Use: Control module, 30769225
Remove the protective tape from the self-adhesive Velcro fastener and install the control module.
Plug in the cable's connector from the cable harness to the control module.
To install, reverse the removal procedure.
Vehicles with fuel pump module originally located in spare wheel well's right trailing edge