V90 L6-2.9L VIN 96 B6304S (1998)
Installing the front suspension
Raise the front suspension to contact. Use the mobile jack.
Note! At the same time align the steering shaft joint.
Install
-
the screws for the front suspension and the engine mountings by hand from underneath the screws for the rear mounting point for the trailing arms.
Tighten to contact the anti-roll bar. Tighten to 50 Nm.
Tightening the front suspension member
Remove the mobile jack.
Lower the car.
Tighten the front suspension screws. Tighten to 95 Nm.
Tighten the engine mounting nuts. Tighten to 50 Nm.
Removing the lifting beam
Remove the lifting beam and accessories.