Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V90 L6-2.9L VIN 96 B6304S (1998)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Testing and Inspection > Page 2040

Page 2
background image

4. Adjusting:
-

Turn off ignition and disconnect battery negative lead.
Adjust the potentiometer. It should show max. resistance of 33 ohms initially.
Reduce resistance by turning clockwise.

-

Check reading as per step 3.

5. Locking potentiometer:
-

Remove battery negative lead.

-

Lock potentiometer by placing a drop of varnish on it. Use a touch-up brush.

-

Wind Insulating tape around the potentiometer so it is protected against shorting.

6. Remove resistor:
-

Remove connector and resistor from gauge connector in trunk.

-

Plug in connector between gauge and sensor again.

-

Reconnect battery.

The connector with resistor can be retained for use on other cars with the same fault.

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Testing and Inspection > Page 2040

[PREV PAGE] [NEXT PAGE]