XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Take screws and the reinforcement bar from the kit. To maintain and adjust the position on the towing member two people should work together
when the screws are entered into the weld nuts of the towing member.
Note! Ensure that the reinforcement bar is positioned correctly, according to the image.
-
Tighten the screws alternately on both sides.
Tightening the screw joint
Torque tighten the screws to 140 Nm (103 lbf.ft.) and angle tighten to till 60°. When angle tightening joints in tight spaces, a protractor applied to a
torque wrench cannot be used. Use instead a Hex screw head to determine the tightening angle. Use workshop lift part no. 9985972 and fixture part
no. 9995972 under the silencer to position it for easier access.
-
Mark the screw head flange (1).
-
Make a second mark (2) in the side member or reinforcement bar.
-
Tighten the screw so that the screw head marking (1) lines up with the marking (2) on the side member/reinforcement bar.
-
Repeat for all screws.