XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Detach the rubber moulding on the front edge of the door opening.
-
Remove the lower A-pillar panel in the front door by first lifting it up at the rear edge. Pull it back until the clip on the centre releases. Then pull it
away diagonally down from the A-pillar panel.
-
Fasten a tape strip on the outer part of the sill, butt with the longitudinal embossing.
-
Measure out 134 mm (5 1/4") from the position where the moulding's front edge should be and mark on the tape strip.