XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Take screws and the mesh from the kit. Tighten the screws at the rear edge of the mesh pocket, with the mesh pocket positioned towards the lower
edge of the side panel.
-
Fold the mesh pocket towards the side panel and ensure that it is against it at the arrow markings.
-
Drill a -3 mm (1/8") hole through the clips and panel at clip (1). Use a 10 mm (25/64")drill stop.
-
Remove any swarf.
-
Take the screw and tighten the clip.
-
Ensure that the mesh pocket is flush at the two front arrow markings. Repeat drilling and tightening as above.
-
Measure out half the distance between the net pocket's eyelets and mark on the side panel, about the same height as the two eyelets.