Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Intake Manifold Gasket > Component Information > Service and Repair > Intake Manifold/Gasket, Replacing > Page 3007

Page 2
background image

-

Disconnect the dip stick pipe

-

Slacken off the lower screws for the intake manifold a few turn

-

Remove the mounting screws in the upper row and the outer screws in the lower row

-

Remove the intake manifold by lifting it approximately 20 mm 

-

Remove the nipple for the water heated crankcase ventilation.

Allow the crankcase ventilation hose to run through the intake manifold without disconnecting it from the flame trap.

Transferring Components When Replacing The Intake Manifold 
Transfer the electronic throttle module.

Use a new gasket.

Tighten.

Installing The Intake Manifold And Gasket 

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Intake Manifold Gasket > Component Information > Service and Repair > Intake Manifold/Gasket, Replacing > Page 3007

[PREV PAGE] [NEXT PAGE]