Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Service and Repair > Left Fuel Gauge Sensor > Page 5102

Page 27
background image

Note! Always clean around any connections that will be disconnected. This is to prevent contaminants from entering the system.

Remove:

-

the guard for the gas tank

-

the connector

-

the four screws
Note! There may be residual pressure in the tank. Slacken off the screws one revolution and release using a screwdriver and allow the gas
to hiss out.

Warning! Take care when working with highly pressurized gas. There is a risk of explosion and cold damage. Carry out any work
outdoors or in a workshop with extraction fans.

the level sensor assembly.

Installing the level sensor assembly

Caution! Before installation, check that the pipe ends and connections are undamaged.

Install:

-

level sensor, assembly with new gasket

-

four screws. Tighten to 6 Nm

-

the connector. Check for leakage.

-

the guard for the gas tank.

Connect the connector in the cargo compartment.

Replacing the electronic level sensor

Hint: The gas tank does not need to be emptied when replacing the analog level sensor.

Removing analog level sensors

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Service and Repair > Left Fuel Gauge Sensor > Page 5102

[PREV PAGE] [NEXT PAGE]