Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Relays and Modules > Relays and Modules - Power and Ground Distribution > Relay Box > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 458

Page 5
background image

Check that the control module connector is intact.

Installing the control module 

-

Press the control module into place so that the catch on the rear engages

-

Position the connector. Carefully press the connector down.

NOTE:  The pins are fragile. Check that the connector goes straight down into the control module.

-

Tighten the screw for the connector

-

Check that the connector cover is correctly positioned. Remedy if necessary

-

Install the relays and shunts.

-

Install the relay box.

-

Install the soundproofing panel on the driver's side.

Finishing 

-

Program in the data read off from the old control module (customer-programmed data for example). This is carried out via VADIS/VIDA vehicle
communication

Relays and Modules > Relays and Modules - Power and Ground Distribution > Relay Box > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 458

[PREV PAGE] [NEXT PAGE]