Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel, Drive Shaft, Replacing > Page 1349

Page 6
background image

-

Secure the new connector to the loose cable

-

Pull up the sensor connector between the fuel tank and bodywork to the other connector

-

Disconnect the cable from the connector

-

Connect the connector for the sensor to the existing connector

-

Reinstall the fuel pump (FP) cover.

Finishing work

-

Fold the soundproofing carpet back into place

-

Reinstall the backrest

-

Install the screw. Tighten to 50 Nm

-

Connect the connector

-

Install the screws and the seat belts. Tighten the screws in the side of the body. Tighten to 50 Nm. Tighten the screws in the floor. Tighten to 80
Nm

-

Install the side backrest panel

-

Fold the seat cushion back into place

-

Install the wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair 

Function test

-

Read off and erase any diagnostic trouble codes (DTCs) stored in the control module

-

Interrupt the diagnostic function by turning off the ignition.

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel, Drive Shaft, Replacing > Page 1349

[PREV PAGE] [NEXT PAGE]