XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! If loudspeakers without mid-range are to be mounted ignore point 4 onwards. Use the same mounting hole as for the existing
loudspeaker.
-
Remove the panel on the door handle. First insert a small screwdriver in the hole (1) in the lower section of the panel and press the catch on the
inside at the same time as pulling the top edge of the panel upwards. If necessary use a plastic weatherstrip tool to pry up the top edge of the cover.
-
Remove the treble loudspeaker (1) in the door panel. Pry it loose using a weatherstrip tool
-
Remove the two screws (2) from under the panel
-
Carefully pry off the door panel using the weatherstrip tool. Start at the lower edge and pry opposite the clips (3).
-
Disconnect the connectors (1) from the door control module and from the existing loudspeaker
-
Remove the wire (2) from the door opener handle (3). First bend up the catches
-
Remove the door panel
-
Remove the panel (4) for the cable lead-in
-
Drill out the rivets (5) from the existing loudspeaker. Use a 6 mm (1/4" ) diameter drill bit
-
Remove the loudspeakers and any rivet swarf from the rivet holes. Also remove any rivet swarf from the door.
