XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Go over the embossed dotted line on the reverse of the insulation panel using a marker pen (see the illustration)
-
Cut out the insulation panel following the marking. Reinstall the insulation panel.
-
Take the left side panel and carefully cut away the insulation on its reverse to expose an area in front of the subwoofer.
Installing the subwoofer
Applies to cars with two rows of seats
-
Take the subwoofer, the four screws and the washer from the kit
-
Secure the subwoofer using the screws in the existing welded nuts above and behind the left-hand rear wheel arch. The washer must be positioned
at the front/lower mounting of the subwoofer.
Applies to cars with three rows of seats
-
Take the subwoofer and the four screws from the kit
-
Secure the subwoofer using the two upper and the lower rear screws in the existing welded nuts. (The front/lower screw is the same as the rear
screw for the panel support.)
-
Reinstall and tighten the panel support. (The washer is not required).
Applies to all models