XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the screw for the lower mounting for the shock absorber. Finger tighten.
Move the control arms to the normal position. See Normal position See: Steering and Suspension/Suspension/Service and Repair/Normal Position.
Tighten:
-
the M12 screws for the tie rod
-
the M12 screws for the lateral link
-
the anti-roll bar link , M12, to the anti-roll bar. Use a Torx wrench as a counterhold on the ball joint so that the rubber boot is not damaged
Tighten (lower control arm):
-
the lower control arm, M12, in the wheel spindle
-
the lower inner control arm mounting, M12, in the sub-frame
-
the lower mounting, M12, in the shock absorber.
Tighten (upper control arm):
-
the rear upper control arm mounting, M12
-
the upper control arm mounting in the wheel spindle, M12.
Removing the tensioner
Remove tensioner. 999 5659 Tension caliper See: Tools and Equipment/999 5659 Tension Caliper See: Tensioner 999 5659, User instructions See:
Steering and Suspension/Suspension/Service and Repair/User Instructions.
Installing the position sensor
Note! Only applies to cars with Bi-Xenon lights.
Install the position sensor for Bi-Xenon lamps. See Position sensor Bi-Xenon lamps, replacing, TF-80SC AWD, AW50/51 AWD, M66 AWD See:
Lighting and Horns/Headlamp/Headlamp Alignment Sensor/Service and Repair.
Installing the exhaust system
Install the exhaust system. See See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Flanged Joint, Assembling
Finishing
Installing wheels
Install the wheels. See: Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Carry out wheel alignment in accordance with: Wheel alignment, checking / adjusting See: Maintenance/Alignment/Service and Repair.
Note! If the vehicle is equipped with Bi-Xenon lamps, the position sensor must be calibrated.