XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
diameter drill bit. Drill at right angles to the underlying surface. Do not enlarge the holes excessively or the rubber nut may not secure.
-
Remove any swarf. Clean around the edges of the holes.
Illustration A
-
Take three screws and thread them through the three upper / middle holes in the skid plate. Take three rubber nuts and screw them 2-3 turns on to
the three screws. The rubber nuts must be turned so that the threaded ends enter into the holes in the bumper during installation.
Illustration B
-
Press the other rubber nuts into place in the drilled holes in the bumper, with the threaded ends first
-
Press the skid plate all the way into place in the three upper / centre holes in the bumper
-
Screw in the other screws as far as they will go
-
Tighten the skid plate with the screws. Tighten to 1.5-2 Nm (1-1.5 lbf.ft.).
Applies to cars with detachable towbars (EU/AUS)
-
Reinstall the cover on the towbar.
