XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Installing the drive shaft
Install new screws on both sides. Use a screwdriver as a counterhold. Tighten to 35 Nm. Angle-tighten 90°. Use bevel protractor 951 2050 BEVEL
PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Installing the skid plate
Move the skid plate up into the bumper wraparound.
Press forwards until the mounting brackets engage in the sub frame.
Install the screws. Tighten to 50 Nm.
Install the splashguard under the engine. Tighten to 24 Nm.
Installing the right-hand engine mounting
Install the right-hand engine mounting. Use new screws. Tighten to35 Nm. Angle-tighten 90°.
Fold the fender liner back into position.
Install:
-
the skid plate
-
the plastic nuts
-
the front wheels. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Installing the clamp for the servo pressure hose
Tighten the clamp for the servo pressure pipe on the sub frame. Tighten to 10 Nm.
Removing lifting tools
Remove lifting tool 999 5716 Reading off tool See: Tools and Equipment/999 5716 Reading off Tool , kit 999 7070 Mounting See: Tools and
Equipment/999 7070 Mounting and lifting hooks 999 5460 Lifting hook See: Tools and Equipment/999 5460 Lifting Hook.
Finishing
Align the wheels. See See: Maintenance/Alignment/Service and Repair