XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the centre console side panel by carefully prying off the panel. Use a weatherstrip tool
-
Remove the panel under the glove compartment by first removing the two screws and then by prying off the panel at the lower edge. The left screw
will not to be used again.
-
Place the panel reverse side up on a flat surface
-
Drill out the two smallest holes marked at the lower edge of the panel using a - 3.5 mm (9/64") drill bit
-
Then drill out the two larger holes using a - 9.5 mm (3/8") drill bit.
Note! Drill the smaller holes in the larger markings and the larger holes in the smaller markings.
-
Drill out the marked hole on the left-hand top edge of the panel. Use a 5 mm (3/16") diameter bit
-
Remove any swarf and even off the hole edges.
-
Press the two lower clips into the net in the lower holes at the lower edge of the panel
-
Lock the clips using two new locking washers.
Hint: Use a 10 mm socket as a counterhold when installing the locking washers.
