XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
the 2 screws for the motor.
Carefully lower the headlining. Position several spacers between the sunroof unit and the headlining to avoid long term kinks.
Remove:
-
1 screw
-
the connector
-
the motor.
Hint: Use a 1/4 ratchet handle with a TORX 25 socket for the last screw.
Installing the electric motor for the sunroof
Note! For tightening torques, see Specifications See: Specifications.
Connect the connector.
Screw the electric motor into place using the 3 M5 screws. Tighten.
Install:
-
the roof module. See Upper electronic module (UEM)/rearview mirror, replacing See: Body Control Systems/Body Control Module/Service and
Repair/Upper Electronic Module (UEM)/Rearview Mirror, Replacing
-
the panel/plastic molding around the headlining/sunroof. Start by pressing one corner into place, continue along a long side and then the shorter
sides and the corners. Finish with a long side.
Check that the sunroof is operating correctly. If this is not the case, see Sunroof module (SRM), calibrating See: Service and Repair/Procedures.
