volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 11934 > < Procedures|Page 11932
Page 1
background image

Air Bag Harness: Removal and Replacement

Wiring harness supplemental restraint system (SRS)

Special tools:

951 2620 Stripping tool See: Tools and Equipment/951 2620 Stripping Tool 
951 2777 Hot-air gun See: Tools and Equipment/951 2777 Hot Air Gun 
951 2785 Crimping tool See: Tools and Equipment/951 2785 Crimping Tool 

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.

Caution! As the SRS system is a safety system, it is extremely important that these instructions are carefully followed when carrying out repairs
in the cable harness.

Caution! Ensure that the new pin has the same type of surface treatment as the old.

Warning! Do not carry out any work on the cable for the SRS system until the connector has been disconnected from the relevant airbag or 
seat belt tensioner. There is otherwise a risk of static electricity deploying the component.

Preparatory work

Selection of repair kit, SRS system

Materials: SRS system repair kit for the selected car.

Note! Only special tools and materials from the SRS system repair kit for the selected car must be used. Choose a repair location where there is
plenty of room to guarantee that work is of the highest quality.

The cables should always be connected colour to colour. If the repair terminal colors do not correspond with the vehicle, check with the wiring diagram
for the vehicle in question. In the cases where the repair terminals have a completely orange cable then this is always fitted to terminal No. 1. In the cases
where the repair terminals have a blue and a brown cable, then blue is No. 1 and brown is No. 2.

Removing the battery lead and the ignition cable

Disconnect the negative battery cable. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting 
Disconnect the relevant ignition cable. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting 

Assembly

Cutting and stripping pairs of cables

Procedures|Page 11934 > < Procedures|Page 11932