XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Control Arm Bushing: Service and Repair
Bushing Outer Control Arm Upper, Replacing
Bushing outer control arm upper, replacing
Special tools:
951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder
999 7031 Locating pin See: Tools and Equipment/999 7031 Locating Pin
999 7030 Mounting bracket bushing replace See: Tools and Equipment/999 7030 Mounting Bracket Bushing Replace
999 7039 Connecting rod M16X360 See: Tools and Equipment/999 7039 Connecting Rod M16X360
999 7054 Adapter incl. 2x MC6C M6X12 See: Tools and Equipment/999 7054 Adapter incl. 2x MC6C M6X12
999 7049 Sleeve See: Tools and Equipment/999 7049 Sleeve
999 7037 Connecting rod M14X400 See: Tools and Equipment/999 7037 Connecting Rod M14X400
999 7038 Drift See: Tools and Equipment/999 7038 Drift
999 7098 Drift See: Tools and Equipment/999 7098 Drift
999 7132 Nut M12 See: Tools and Equipment/999 7132 Nut M12
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Remove the rear wheels.
Removing the wheel spindle
Remove:
-
the screw for the mounting in the tie rod (1)
-
the screw for the mounting in the control arm (2)
-
the nut for the mounting in the anti-roll bar link (3).
Counterhold using a Torx wrench so that the boot does not rotate.
Disconnecting the control arm