XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Pipe/Service and Repair/Flanged Joint, Assembling.
Installing the sub-frame
Note! Only applies to cars with AWD.
Install:
-
the final drive
-
the 3 M12 screws for the final drive
-
the drive shafts
-
the anti-roll bar
-
the 4 x M10 screws for the anti-roll bar in the sub-frame
-
the anti-roll bar
-
the 4 x M10 screws for the anti-roll bar in the sub-frame.
Installing the shock absorber
Raise the new shock absorber to the upper mounting.
Install the new nut.
For tightening torques, see Specifications See: Steering/Specifications/Mechanical Specifications.
Note! Make sure that the bushing seats correctly in the opening in the rear end.
Install:
-
the sub-frame
-
the M12 screws for the sub-frame cover
-
the carbon filter container
-
the M6 screws for the carbon filter container.
Installing the upper control arm
Install:
-
the screws for the rear control arm mounting. Only tighten a few turns
-
the front upper control arm mounting, M12.
Installing the wheel spindle
Install the screw on the outer control arm mounting in the wheel spindle. Only tighten a few turns.
Note! Only applies to cars with AWD.
Install the drive shaft in the wheel spindle, M10.
Lifting sub-frame
Lift up the sub-frame approximately 100 mm from the upper position.
Install:
-
the clamp for the hose on the pressure pump
-
the pressure pump on the bracket
-
the plastic clips.
Raise the sub-frame to the upper position.
Install:
-
the bracket for the fuel pre-filter, M6
-
the bracket for the brake pipe, M6
-
the M6 screws for the front mounting for the bracket on the sub-frame
-
the 4 x M12 screws for the sub-frame. For model year 2005- see Tightening torque See: Steering/Specifications/Mechanical Specifications.
Installing the propeller shaft
Note! Only applies to cars with AWD.
Install:
-
the propeller shaft
-
the 4 x screws for the propeller shaft. Tighten. See See: Specifications/Mechanical Specifications/Automatic Transmission/Transaxle/System