XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Stabilizer Link: Service and Repair
Anti-Roll Bar Link Rear, Replacing
Anti-roll bar link rear, replacing
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Removing the anti-roll bar link
Remove:
-
the wheel
-
the anti-roll bar link from the mountings. Use a Torx wrench as a counterhold so that the boot is not damaged.
Installing the anti-roll bar link
Install the anti-roll bar link.
Use new nuts. Tighten the nuts. Tighten to 80 Nm.
Use a Torx wrench as a counterhold so that the boot is not damaged.
Install the wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
