XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install a new lubricated nut.
Note! There must be no axial play.
Tighten to 180-200 Nm. Use counterhold 999 5652 Counterh. See: Tools and Equipment/999 5652 Counterh. with adapter 999 7058 Adapter See: Tools
and Equipment/999 7058 Adapter.
Note! Do not exceed a tightening torque of 200Nm. The forces on the pinion bearing may become too great, causing it to seize.
Installing the propeller shaft
Check that the mating surfaces on the propeller shaft CV joint and flange are clean.
Align the propeller shaft CV joint against the flange.
Install the screws loosely in the support for the centre bearing and the propeller shaft.
Install the propeller shaft using the marking made earlier
Tightening the propeller shaft CV joint
Use new screws.
First tighten the screws crosswise. Tighten to 8 Nm. Then tighten to 30 Nm.
Use counterhold 999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold.
Tighten the screws for the support for the center bearing. Tighten to 25 Nm.
Tighten the screws for the propeller shaft center bearing. Tighten to 25 Nm.
Installing the three-way catalytic converter (TWC)
Install the catalytic converter, see Three-way catalytic converter (TWC), replacing See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair.
Checking the oil level in the bevel gear
