XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove:
-
the screws from the bracket for the gear selector cable
-
the cable from the lever. Use special tool 999 7077 Jimmy bar See: Tools and Equipment/999 7077 Jimmy Bar. Move the cable to one side.
Removing the gear-shift position sensor from the gear shift linkage rod
Remove:
-
the lever
-
the nut, lock washer and rubber seal from the gear-shift position sensor
-
the 2 screws for the gear-shift position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Installation
Note! For tightening torques, see See: Specifications/Mechanical Specifications/Tightening Torque
Replacing the sealing ring for the gear-shift linkage rod