XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove the old sealing ring. Use a small rounded off screwdriver.
Take care not to damage the rod.
Smear a little automatic transmission fluid on the new sealing ring. Install the ring. Use drift 999 5476 PUNCH See: Tools and Equipment/999 5476
Punch.
Installing the gear-shift position sensor
Tighten the sensor screws lightly.
Install the rubber washer, lock washer and the nut on the gear shift linkage rod connection.
Tighten the nut.
Lock the nut with the lock washer.
Adjusting gear-shift position sensor
Adjust the gear-shift position sensor. See Gear-shift position sensor, checking/adjusting See: Sensors and Switches - A/T/Transmission Position
Switch/Sensor/Adjustments.
Installing the gear-shift position sensor, continued
Install:
-
the lever on the gear shift linkage rod. Tighten. See
-
the gear selector cable and bracket on the transmission using 2 M8 screws. Tighten