XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the cap nut from the extractor
-
Install the extractor bracket and nut
-
Remove the seal
-
Check that no seal residue is left.
Lubricate the edges of the new seal using automatic transmission fluid.
Install locating pin999 5769 Pilot See: Tools and Equipment/999 5769 Pilot.
Install the seal on the locating pin. Use drift 999 5771 Drift See: Tools and Equipment/999 5771 Drift.
Tap in the seal until the drift is against the transmission.
Remove the locating pin.
Install the drive shaft. See Replacing the front right drive shaft See: Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing.
Check the oil level. See Oil level, checking See: Automatic Transmission/Transaxle/Service and Repair/Procedures/Oil Level, Checking.
Seal, Drive Shaft, Replacing
Seal, drive shaft, replacing
Special tools:
999 1801 Standard Shaft See: Tools and Equipment/999 1801 Standard Shaft
999 5729 Drift See: Tools and Equipment/999 5729 Drift
999 5730 Drift See: Tools and Equipment/999 5730 Drift
999 5731 Puller See: Tools and Equipment/999 5731 Puller
999 5732 Puller See: Tools and Equipment/999 5732 Puller
Left-hand side
Preparations
See and Half shaft, left, replacing See: Axle Shaft Assembly/Service and Repair/Drive Shaft Left, Replacing
Remove the drive shaft seal