volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 17
background image

-

Screw the turbocharger stay in the turbocharger with the short screw (2) and into the other mounting in the engine block with the screw (3).

-

Tighten the screws to 16 Nm (12 lbf.ft.).

-

Take the radiation protection and cable from the kit. Thread the radiation protection onto the cable and connect the cable to the heater

-

Install the locking sleeve on the heater's connector.

Install:

-

air baffle

-

the splash guard. Tighten the screws to 25 Nm (18.5 lbf.ft.).

-

the decal from the kit.

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Engine Block Heater > Component Information > Service and Repair > Relay Electrical Engine Block Heater, Replacing > Page 3133

< PREV PAGE NEXT PAGE >