Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 3323

Page 1
background image

Crankshaft Main Bearing Seal: Service and Repair

Crankshaft seal rear, replacing

Special tools:

999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector 
999 7174 Drift See: Tools and Equipment/999 7174 Drift 
999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft 
999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw 

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.

Removal

Removing the flywheel and carrier plate

Remove the gearbox:

-

manual transmissions. See Transmission, removing See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement.

-

automatic transmissions. See Gearbox, removing See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement.

Remove the flywheel / carrier plate. Use gear sector 999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector as a counterhold when
slackening off the screws.

Removing the seal

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 3323

[PREV PAGE] [NEXT PAGE]