Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Cylinder Head Gasket > Component Information > Service and Repair > Page 3340

Page 11
background image

Install new O-rings around the spark plug wells at the cylinder head.
Apply liquid gasket 1161 059 to the camshaft cover.
Use roller 951 2767 Roller See: Tools and Equipment/951 2767 Roller. The surface must be covered without any excess.

Note! Make sure that no liquid gasket ends up in the oil channels.

Installing the camshaft cover

-

Lubricate the camshaft lobes, the camshaft bearing surfaces and the valve lifters

-

Install the camshaft cover

-

Install press tool 999 5454 PRESS TOOL See: Tools and Equipment/999 5454 Press Tool (2x).

-

Tighten the camshaft cover screws alternately, keeping it parallel to the cylinder head using the press tools

-

Install all the screws. Tighten the screws from the middle and outwards

-

Remove the press tools.

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Cylinder Head Gasket > Component Information > Service and Repair > Page 3340

[PREV PAGE] [NEXT PAGE]