XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Note! Use new O-rings lubricated with compressor oil.
Connect the pipe to the receiver drier.
the hose / pipe from the member to the compressor
the pipe lock on the pipe holder
the pipe on the expansion valve using 1 M6 screw. Tighten
the heat shield for the expansion valve
the drainage channel and the plastic nut
the clamp for the refrigerant pipe
the outlet air pipe
the expansion tank
the connector at the cable duct
the switch for the level sensor
the hose on the expansion valve
the servo oil reservoir
the engine stabilizer brace in the engine compartment.
Carry out finishing work. See Finishing work (operations common to all methods).
Pipe/hose junction block cowl - rear expansion valve, replacing
Removing the pipe / hose from the junction block on the cowl - rear expansion valve
the left front seat. See Upholstery back rest, replacing See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat, Driver's Seat, Front
Seat/Upholstery Backrest, Replacing (-2004) or Front seat, replacing (2005-)
the dashboard. See Dashboard, replacing See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Angle out the climate control unit. See Climate unit, replacing See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Climate
Remove the rear sill trim panel. See Sill trim panel, replacing See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Sill Trim
Lift the rear floor carpet and the lower floor surface to one side.
Remove the rear side panel. See Side panel cargo compartment, replacement See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Side Panel Cargo Compartment, Replacement.
Detach the connection at the junction block in the engine room for the rear pipes.
Remove the heat deflector and the seal on the cowl panel.
Disconnect the terminal at the rear air conditioning (A/C) unit.
Installing the pipe / hose on the junction block on the cowl - rear expansion valve